61
Troubleshooting
When the base information is deleted, the handset displays Handset not registered-place handset on base to
register. See your Owner’s Manual for help.
Re-register the handset to the base (see Registering accessory handsets on page
13).
If the handset cannot contact the base, it will display
Out Of Range. Make sure the handset is in range of the base
and the base is connected to power; you can also reset the handset without the base (see the next section).
Resetting the Handset Without the Base
If your original base is not available for some reason, you can still reset the handset and use it with another base.
Press and hold
END and # for at least ve seconds.
Move the cursor to select
Base Unavailable and then press MENU/SELECT.
Select the base which you want to de-register from, and then press MENU/SELECT.
Base Unavailable appears.
Move the cursor to select
Yes, and then press MENU/SELECT. You hear a conrmation tone, and the handset
deletes its own base information without contacting the base. If the handset was registered to only one base,
it displays
Handset not registered-place handset on base to register. See your Owner’s Manual for help. If the
handset is still registered to another base, it searches for the other base and then returns to standby.
Register the handset to the new base (see Registering accessory handsets on
page 13).
5)
6)
1)
2)
3)
4)
5)
To Next Page
Loading...
Need help?
General
