3737
Adjusting the Ringer,
Earpiece and Speaker Volume
Base Speaker: You can choose from ten volume levels for the base speaker when the answering system
announces or plays a message. To adjust the base speaker volume, press VOLUME
(to make it louder) or
VOLUME
(to make it softer).
Adjusting the Audio Tone
If you aren’t satised with the audio quality of your phone, you can adjust the Audio Tone of the earpiece while on
a call. Your phone gives you three audio tone options: low, natural and high; the default setting, Natural Tone, is
recommended for hearing aid users. Audio tone adjustments only apply to the earpiece, not the speakerphone.
To adjust the audio tone:
While on a call, press MENU/SELECT
.
Move the cursor to select
Audio Tone, and then press MENU/SELECT.
Move the cursor to select desired option (
High Tone, Natural Tone, or Low Tone), and then press MENU/
SELECT. Selected option appears in the display for two seconds, and then the display returns to normal.
Activating T-Coil Mode
Digital cordless phones generate magnetic signals that can cause noise on hearing aids equipped with a telecoil
(“T” coil) feature. This phone includes a special “T-coil” mode that, when activated, reduces the magnetic noise
generated by the handset.
With the phone in standby, press
MENU/SELECT.
Select the
Handset Setup menu, and then the T-coil submenu.
Move the cursor to select
On or Off.
Press
MENU/SELECT. You will hear a conrmation tone.
When the T-coil mode is turned on,
appears in the display during a call.
Note: Using the T-coil mode may shorten the handset battery’s talk time; make sure you always return the handset
to the charging cradle when not in use. Only activate T-coil mode if you experience problems using the
handset with a T-coil-equipped hearing aid.
1)
2)
3)
1)
2)
3)
4)
To Next Page
Loading...
Need help?
General
