Setting the Message Alert On or Off
Setting the Call Screen
Message Alert sounds an alert tone when you have an unheard message. If you set
Message Alert on, whenever a new message is received, the soft alert tone will sound every
15 seconds. When all messages have been played back, the alert tone automatically
deactivates.
1) Press the soft key. Select the Answ.
Setup menu, and then the Message Alert submenu.
2) Press to select or .
3) Press the soft key on the base or handset.
You will hear a confirmation tone.
To quickly turn off the Message Alert tone, press any key on the base unit; the tone will
automatically deactivate.
When all new messages are played back using the remote playback feature (see pages 58
to 61),the Message Alert tone will automatically deactivate. The tone will not deactivate until
all new messages are played back.
Call Screen allows you to listen (from the base) to the incoming message being left
by the caller before you answer the call.
1) Press the soft key.
Select the Answ. Setup menu and then the Call Screen
submenu.
2) Press to select or .
3) Press the soft key. You will hear a confirmation tone.
MENU
OK
Turning the Message Alert tone off by pressing any key
Turning the Message Alert tone off from a remote location
MENU
OK
/volume up/down
/volume up/down
On Off
On Off
BACK OK
Call Screen
Off
On
BACK OK
Message Alert
Off
On
[24]
GETTING STARTED