Setting the Ring Time
Setting the Record Time
Ring Time allows you to set the number of rings the caller hears before your answering
system plays the outgoing message. You can set the ring time to answer after four, six or
nine rings. If you enable the Toll Saver (TS), the answering system picks up after six rings if
you have new messages, and after nine rings if there are none.
1) Press the soft key. Select the Answ. Setup menu,
and then the Ring Time submenu.
2) Press to select a Ring Time
(4 Times, 6 Times, 9 Times or Toll Saver).
3) Press the soft key. You will hear a confirmation tone.
Record Time sets the duration for recording the incoming messages. You have three record
time options: "1 minute" "4 minutes" or "Announce Only". "Announce Only" answers the call
but prevents the caller from leaving a message.
1) Press the soft key. Select the Answ.
Setup menu, and then the Record Time submenu.
2) Press to select Record Time
(1 Minute, 4 Minutes, or Announce Only).
3) Press the soft key. You will hear a confirmation tone.
MENU
OK
MENU
OK
/volume up/down
/volume up/down
BACK OK
Ring Time
Toll Saver
9 Times
BACK OK
Record time
4 Minutes
1 Minute
[23]
To Next Page
Loading...
Need help?
General
