UniFlow MiCard MultiTech4 - Page 48

MiCard MultiTech4
36
Question
Answer
Question ID
The customer would like to remove
leading zeros (e.g., 0001234 should
be 1234). Can this be configured in
the AppBlaster (NT-ware Edition)?
Yes, go to Transponder Types > Output Format and set
Minimum to 1 digit in the Length of Output section.
MMT014
Is the NT-ware Mobile Badge BLE
app also available for
smartwatches?
No, this is currently not available.
MMT015
Is Orange PackID as a smartphone
identification solution supported by
the MiCard MultiTech4 BLE card
readers?
Yes, this is available on a project basis. Please create a MOMPS
ticket, and the NT-ware Project Team will help you.
MMT016
Can the MiCard MultiTech4 BLE card
readers be utilized with HID Mobile
Access?
No, this is currently not possible.
MMT017
Is the "Tracer Mode" also available
for MiCard MultiTech4 BLE card
readers?
Yes, the Tracer app is available in the Firmware folder of the
AppBlaster (NT-ware Edition) package.
MMT018
MiCard MultiTech4 BLE card readers
and NT-ware Mobile Badge BLE app
have been launched with uniFLOW
2020 LTS. Can we use them with
previous uniFLOW versions as well?
Yes. All MiCard MultiTech4 card readers can be utilized with
any uniFLOW / uniFLOW Online version.
MMT019
For any questions regarding MiCard MultiTech4 card readers or transponder type
support and configuration, open a MOMPS ticket, and the NT-ware Project Team will
help you.