To Next Page

To Previous Page

TD 92930EN

13 December 2013 /Ver B

Configuration Manual

WL3 and WL3 Plus WLAN Handset

4. Installation of WLAN Handsets

Installation steps in large VoWiFi Systems using WSG and WinPDM

NOTE: If the handset to be installed must use a certificate to access a WLAN, follow

the instructions in section

4.3 Installation with WinPDM on page 13.

These WLAN settings are common network settings for all handsets.

1 Create templates in the Device Manager in WSG, one with network settings and

another with common settings.

2 Create Numbers and apply the templates.

3 Use either the Easy Deployment procedure, or create a template with identical

network settings in the WinPDM.

See 4.1 Handset Installation in the WLAN System using Easy Deployment on page 9 or

4.2 Installation with Central Device Management (WSG) on page 9 for more

information.

Installation steps in small VoWiFi Systems using WinPDM

1 Create Numbers.

2 Create one template for all settings in the WinPDM.

See 4.3 Installation with WinPDM on page 13 for more information.

4.1 Handset Installation in the WLAN System using Easy Deployment

With the Easy Deployment procedure, handsets are installed without the need for the

WinPDM.

Handsets are automatically installed if the following is fulfilled:

• The LAN and WLAN system is configured for Easy Deployment, see Appendix C:

Easy Deployment on page 89.

• The handset is not associated to any network (SSID)

• The handset software is version 5.1.18 or higher

• The Call ID (endpoint number), that is, the phone number of the handset is decided

For further details, see Appendix C: Easy Deployment on page 89.

4.2 Installation with Central Device Management (WSG)

Easy Deployment is the recommended procedure of using the Central Device

Management (WSG) for deployment, as the WLAN and Messaging parameters now

are configured without the WinPDM.

Easy Deployment uses, in most parts, the same procedure, as the standard Central

Device Management (WSG) procedure. Special notes marked “(ED)” show where the

procedure is unique for Easy Deployment.

NOTE (ED): With Easy Deployment, it is very important that the building of the number

plan and the parameters are correct, since the aim is to avoid using the WinPDM.

Unify OpenStage WL3 Administration Manual

Other manuals for Unify OpenStage WL3