TD 92930EN
13 December 2013 /Ver B
Configuration Manual
WL3 and WL3 Plus WLAN Handset
31
6. Handset Configuration
6.2 IP Address Settings
The IP address settings can be configured in two ways.
• The handset can configured to receive an IP address automatically from a DHCP
server, see
6.2.1 Automatic IP Address Settings.
• If no DHCP server is used, a unique IP address must be entered manually for each
handset, see
6.2.2 Static IP Address (Manual) Settings.
6.2.1 Automatic IP Address Settings
1 Select Network > Network A (or B, C, D).
2 In the DHCP mode drop-down list, select “Enable”.
The Phone IP address, Subnet mask, and Default gateway are automatically set up.
6.2.2 Static IP Address (Manual) Settings
1 Select Network > Network A (or B, C, D).
2 In the DHCP mode drop-down list, select “Disable (static mode)”. Additional
parameters will be displayed.
3 In the Phone IP address field, enter the unique IP address for the handset.
4 In the Subnet mask field, enter the subnet mask.
5 In the Default gateway field, enter the IP address for the default gateway.
DNS Server Settings
It is possible to configure the DNS server that the handset uses. If the primary DNS
server is available, it is always used. Otherwise, the secondary DNS server is used.
NOTE: The DNS parameters are only visible if the DHCP mode is set to “Disable (static
mode)”, see
6.2.2 Static IP Address (Manual) Settings.
Primary DNS Server
1 Select Network > Network A (B, C, or D).
2 In the Primary DNS field, enter the IP address for the primary DNS server.
Secondary DNS Server
1 Select Network > Network A (B, C, or D).
2 In the Secondary DNS field, enter the IP address for the secondary DNS server.
6.3 Network Settings
6.3.1 SSID
The SSID is the name of the network that the handset associates with.
1 Select Network > Network A (B, C, or D).
2 In the SSID field, enter system SSID.
Note that the SSID is case-sensitive.
To Next Page
Loading...
Need help?
General