EasyManuals Logo

Unify OpenStage WL3 Administration Manual

Unify OpenStage WL3
113 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #61 background imageLoading...
Page #61 background image
TD 92930EN
13 December 2013 /Ver B
Configuration Manual
WL3 and WL3 Plus WLAN Handset
53
6. Handset Configuration
TIP: It is recommended to use these settings, if messages regardless of priority are
read in chronological order, that is, the newest message is displayed first.
Figure 7. Display messages in chronological order regardless of priority
In figure 7, a message with priority 1 is received at 13:59. Another message with
priority 2 is received at 14:02 and is displayed. The message with priority 1 is put in the
message queue. The user needs to close the current message (priority 2) to show the
message (priority 1) in the queue. When closing the message (priority 2) it is indicated
as a read message in the Messaging Inbox.
6.9 Alarm Settings
NOTE: Applicable to WL3 Plus only.
The following alarm types can be configured; Push-button alarm, Test alarm,
Emergency call alarm, Man-down and No-movement alarm.
6.9.1 Common Alarm Settings
These settings are common for all alarms sent from the handset.
1 Select Alarm > Common.
2 In the Stored alarm data field, enter data to be sent along with an alarm
(optional).
3 In the Indicate initiated Alarm drop-down list, select one of the following:
On - The handset will beep and the LED will flash twice when an alarm is
initiated.
Off - The handset will not indicate when an alarm is initiated.
4 In the Disable backlight during alarm drop-down list, select one of the following:
Yes - The display backlight will be left unchanged for 30 seconds after alarm
No - The display will light up after an alarm.
6.9.2 Push Button Alarm
NOTE: Applicable to WL3 Plus only.
1 Select “Alarm“.
2 Select “Multiple-press“ or “Long-press“.
3 In the Alarm type for multiple press drop-down list or Alarm type for long press
drop-down list, select “Push button alarm 1“.
Prio 2
13:59
Prio 2
13:59
Prio 2
13:59
The user closes
the message
Prio 2
14:02
New messages
Prio 1
13:59
Prio 1
13:59
Prio 2
14:02
Messaging Inbox
Prio 2
14:02
Prio 1
13:59
Prio 1
13:59

Table of Contents

Other manuals for Unify OpenStage WL3

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Unify OpenStage WL3 and is the answer not in the manual?

Unify OpenStage WL3 Specifications

General IconGeneral
BrandUnify
ModelOpenStage WL3
CategoryHandsets
LanguageEnglish