Unify OpenStage WL3 Administration Manual

TD 92930EN
13 December 2013 /Ver B
Configuration Manual
WL3 and WL3 Plus WLAN Handset
33
6. Handset Configuration
NOTE: The selected World Mode Regulatory Domain defines which channels to be
used. See
Bands and Channels used by WiFi a-radio.
•All
•Non DFS
• UNII-1
• UNII-3
• UNII-1, UNII-2
• UNII-1, UNII-2, UNII-3
• UNII-1, UNII-2, UNII-2 Extended
• Advanced
Bands and Channels used by WiFi a-radio
802.11 b/g/n Channels
Defines the 802.11b/g/n channels to use. It is recommended to use the default value
“1,6,11“. If set to “All”, all channels are scanned for APs, which decreases the WLAN
performance. Select “Advanced“ only if the channels are to be set in the parameter
Advanced: 802.11 channels.
1 Select Network > Network A (B, C, or D).
2 In the 802.11 protocol drop-down list, select “802.11b/g/n“.
3 In the 802.11b/g/n channels drop-down list, select one of the following:
•All
• 1,6,11
• Advanced
Advanced: 802.11 Channels
Defines which 802.11 channels to use. Only used if the parameter in the 802.11b/g/n
channels, or 802.11a/n channels is set to “Advanced“.
NOTE: It is not possible to scan channels in 802.11b/g/n and 802.11a/n simultaneously.
1 Select Network > Network A (B, C, or D).
2 Enter channels to scan in a comma-separated list, for example 1,6,11 (the order
has no impact; 11,6,1 will give the same result).
Frequency band Channels
Non DFS 5.150 - 5.250 MHz,
5.725 - 5.845 MHz
36,40,44,48
149,153,157,161, 165
UNII-1 5.150 - 5.250 MHz 36,40,44,48
UNII-2 5.250 - 5.350 MHz 52,56,60,64
UNII-2
Extended
5.470 - 5.725 MHz 100, 104, 108, 112,116, 120, 124, 128, 132,
126, 140
UNII-3 5.825 - 5.835 MHz 149,153,157,161

Unify OpenStage WL3 Specifications

General

Brand	Unify
Model	OpenStage WL3
Category	Handsets
Language	English