Unilumin UTV-P User Manual

Chapter 7 Instructions for operation under iOS System
Chapter 7 Instructions for operation under iOS
System
Search the App Store for LED Assistant and download the installation.
7.1 Use environment
When using mobile device control of iOS, you need to connect the control device to
the hotspot issued by UTV-P, or the control device and UTV-P to connect to the
same local area network.
7.1.1 Control device access to UTV-P hotspots
UTV-P emits a hotspot by default, which is enough for the first time with a direct
connection. The hotspot name is C6-XXXX, the initial password is 123456789, and if
you need to modify it, refer to the 4.2.2 network settings section.
7.1.2 Control device and UTV-P access to LAN
UTV-P can be connected directly to the router with a network cable, and then the
control device can be connected to the router network.
If you need wireless access to the network, you need to connect your computer to set
up the UTV-P network:
1) Use the data cable to connect UTV-P with the computer, the computer end to the
USB port, UTV-P access to CONFIG port;
2) Open the computer control software, enter the settings interface:
50

Unilumin UTV-P Specifications

General

Brand	Unilumin
Model	UTV-P
Category	Monitor
Language	English