Uninet iColor - iColor Coater Electrical Installation

11
Installing your iColor coater - Electrical
Once you have placed your iColor coater it is time to install the equipment. The iColor coater can be
installed by Certified iColorTechnician / iColor Dealer or by the customer after reading and following
the detailed directions provided in this manual.
CAUTION: A licensed / certified electrician MUST connect the iColor coater to the plant power.
1.
Place the iColor coater in the desired operating location. Remember to provide at least 3 feet (1
meter) of space around the iColor coater for operation and service.
2.
The iColor coater is equipped with approximately 8ft of electrical cord.
3.
Have the Electrician connect the iColor coater cord to the existing plant power.
4. If it is necessary to hardwire the equipment, it is very important that it is completed by a licensed /
certied electrician.
WARNING: Once the power is connected, be sure to have the Electrician check with an electri-
cal meter prior to turning the system on. Too much power will blow the breaker or cause severe
damage to the equipment. Too little power and the system will not power up.
Figure - Electrical cord