31
Five Kwik & EZ Ways to Perfect the Coating Finish
1. Increasing/Decreasing Belt Speed.
BELT SCREEN
• The speed is controlled by the Left & Right Arrow Keys, whether the belt is ON or OFF
2. Increasing/Decreasing UV Lamp Intensity.
UV LAMP SCREEN
• The UV Bulb Intensity is controlled by the Left & Right Arrow Keys. This can ONLY be adjusted
when the lamp & belt are ON.
3.
Increasing/Decreasing Coating Unit Pressure.
a. Increasing pressure will Decrease the amount of Coating.
b. Decreasing the pressure will Increase the amount of Coating.
4. Increasing/Decreasing Form to Impression Roller Pressure.
a. Increase pressure if areas on sheet have little or no coating.
b. Decrease pressure if the Form Roller is contacting the Impression Roller.
5. Changing Coating.
Figure - Coating Unit Pressure Figure - Impression Roller
Pressure
Figure - Coating
To Next Page
Loading...
