4
Safety & Precautions
Before unpacking, installing and operating the iColor Coater, please make sure you read and follow
these safety instructions.
The iColor coater can be installed by the customer after reading and following the detailed
directions provided in this manual.
CAUTION: The operator of the iColor coater must take extreme caution during the running of
the machine to prevent the possibility of a Fire!
When feeding stock you must make sure it is exiting the machine, i.e. not getting jammed in
the delivery area or it will catch on Fire!
CAUTION: A
Class A,B,C fire extinguisher and a metal garbage can with a metal lid should be
located in close proximity to the iColor coater system in case a coated sheet gets caught under
the lamp and catches fire.
Class A extinguishers are for ordinary combustible materials such as paper, wood,
cardboard and most plastics.
Class B res involve ammable or combustible liquids such as gasoline, kerosene,
grease and oil.
Class C res involve electrical equipment, such as appliances, wiring, circuit breakers
and outlets. Never use water to extinguish class C res - the risk of electrical shock is
far too great!
CAUTION: Those coatings cannot be used which build an explosive atmosphere when being
heated up under the UV Dryer.
CAUTION: A licensed / certified electrician MUST connect iColor coater to the plant pow-er.
CAUTION: Do not connect or disconnect any power cables or perform any maintenance to
the iColor coater while the system is powered on.
WARNING: Some of the components (i.e. UV lamp housing, bulb and duct) of the iColor
coater system may become hot during normal operation. Use care when handling or touching
these components.
To Next Page
Loading...
Need help?
General
