UBio-X Pro2 User Guide 16
UNIONCOMMUNITY Co., Ltd.
Addr : 12F, Munjeong Daemyeong Valeon bldg, 127 Beobwon-ro Songpa-gu,
Seoul, Korea (zip code: 05836)
Tel: +82-2-6488-3000, Fax: +82-2-6488-3099,
E-Mail :sales@unioncomm.co.kr; http://www.unioncomm.co.kr
1.6. How to register and authorize the face properly
Face registration method
- Maintain the distance between the terminal and face in about 50 cm.
(Locate the face in the guide line of LCD window.)
- Register the face pose along with the guidance. During the shooting, please
maintain the attention.
- When registering the face, register after sweeping your hair up not to hide the
eyebrow or lower face with your hair or hat. (On the stand of passport picture).
Face authentication method
Just stare at the camera from the front.
Notes
- It is recommended to register and authorize at the location where the terminal is
installed.
- If you pose differently with the registered face, the recognition rate of face can
decrease. It is good to locate the full face as much as possible
- The thick glasses frame or sun-glasses can decrease the recognition rate of face
Cautions in the installation
- Be sure to install the terminal indoor.
- Do not install under the light bulb.
- Not recommended in the circumstance of backlight or direct light.
1.7. Proper fingerprint registration and input methods
Correct fingerprint registration methods
Place your index finger on the window just as you do with a finger stamp.
Do not use the tip of the finger.
Make sure the center of your finger touches the window.