Unipulse F370 - Stop Bit; Terminator; Communication Modes

11.RS-232C INTERFACE(OPTION)
82
11-2-5. Stop Bit
1 bit, 2 bit
How to set
11-2-6. Terminator
CR，CR ＋ LF
How to set
11-3. Communication Modes
1.Communication Mode 0
Communications are carried out by commands from the host computer.
The indicated value, status and parameters can be read, and parameters can be written.
2. Communication Mode 1
The indicated value and status are continuously transmitted.
3. Communication Mode 2
The indicated value is transmitted upon printing.
Setting call Page 1
→
→
Option
Setting call Page 2
→
→
Option