Unipulse F370 - Page 99

11.RS-232C INTERFACE(OPTION)
88
- Reading parameters
- Commands (Host → F370)
Digital Zero
Digital Zero reset
Print instruction
2. Communication mode 1
The indicated value is continuously transmitted.
3. Communication mode 2
The indicated value is transmitted upon printing.
Host
F370
Ｗ
Ｗ
CR
Set Value No. The same format as write-in
of set values.
Set Value No.
Terminator
CR
CR
CR
Ｃ
Ｃ
Ｃ
G
Ｆ
Ｉ
（This is effctive only when the set value
（This is effctive only when the set value
（This will issue print a command onto SIF.）
LOCK is "1."）
LOCK is "1."）
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21
G S ， 1 ， 2 ， 3 ， 4 ， 5 ， ±
****
HEADER
Five digits of the indicated
Sign
＋ or －
*
Terminator
value and decimal point
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21
G S ， 1 ， 2 ， 3 ， 4 ， 5 ， ±
****
HEADER
Five digits of the indicated
Sign
＋ or －
*
Terminator
value and decimal point