24
All valid settings
include 00, 01, 02, 03, 04, 10, 11, 12, 13, 14, 20, 21, 22, 23, 24, 30, 31, 32, 33, 34, 40, 41, 42, 43,
and 44.
Element amendment: If it is enabled, the scanner can read the barcode comprised with bars and
spaces in different scale.
Character output restraint:
Printable character only- If this option is selected, the scanner will output the printable
characters only, i.e. in ASCII from 20H to 7EH.
Alphanumeric character only- If this option is selected, the scanner will output the
alphanumeric characters only, i.e. “A”-“Z”, “a”-“z”, “0”-“9”.
Decoder optimization: If it is enabled, the scanner will optimize the decoder with error correction.
This function is not effective for all types of barcodes.
Data output delay in continue-scan mode: If it is enabled, in the continue-scan mode, the
scanner can store the data while continue-scanning. The scanner will output the data after the
predefined delay elapsed. The maximum storage of data is 1000 characters. If this parameter is
set to be “00”, the scanner will not store data. And if the parameter is set to be “FF”, the scanner
will output data after stopping scanning.
Character encoding system: A character encoding system consists of a code that pairs each
character from a given repertoire. Common examples include Morse code, the Baudot code, the
ASCII and Unicode. If the data received does not display with the proper characters (e.g. domestic
language), it maybe because the barcode being scanned was created using a character encoding
system that is different from the one the host program is expecting. Try alternate options to find the
proper one.
Complete data output before next decode attempt: This setting is active only when USB device
type is set as “HID keyboard” or “HID keyboard for Apple Mac”, refer to 3-6 USB interface. If it is
enabled, the scanner will not start next decode attempt until previous data output is completed.
To Next Page
Loading...
