EasyManuals Logo

Unitech MS920 User Manual

Unitech MS920
146 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #131 background imageLoading...
Page #131 background image
122
<SW>704601
Scanning / Triggering - Turn off after good read - Disable
<SW>704600
Retrigger delay
- Only valid if "Turn off after good read" is disabled.
- This setting is a time delay in which the scanner turns off after a good read.
When the delay is done, the scanner automatically turns back on (retriggers).
- Value is in milliseconds.
Scanning / Triggering - Turn off after good read - Retrigger delay - 0 (*)
<SW>70860000
Aimer mode
- Allows you to locate the bar code you want to read.
- The aiming beam is only used with the following trigger modes:
- Level
- Pulse
- Autostand
- Toggle*
-NOTE*: In Toggle trigger mode, "one pull aim, one pull read" does not work as
stated. Instead one pull turns on the aimer only. When the trigger is released
decoding begins. If no decode, second pull turns aimer and decoding off.
Scanning / Triggering - Aimer mode - Typical aimer (*)

Table of Contents

Other manuals for Unitech MS920

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Unitech MS920 and is the answer not in the manual?

Unitech MS920 Specifications

General IconGeneral
BrandUnitech
ModelMS920
CategoryScanner
LanguageEnglish

Related product manuals