UAD Powered Plug-Ins Manual - 365 - Chapter 42: SPL Transient Designer
• Shorten the sustain period of a snare or a reverb tail in a very musical way
to obtain more transparency in the mix.
• When recording a live drum set, shorten the toms or overheads without
physically damping them. Usual efforts to damp and mike are reduced re-
markably. Since muffling of any drum also changes the dynamic response,
the Transient Designer opens up a whole new soundscape.
• Micing live drums is considerably faster and easier because you can correct
the apparent “distance” of the microphone by simply varying the ATTACK
and SUSTAIN values.
• The Transient Designer is a perfect alternative to noise gates in live drum
micing. Adaptively reacting to the duration of the original signal, the sustain
is shortened more musically than with fixed release times and a drumset is
freed from any crosstalk quickly and effectively.
• Create unusual dynamic effects including new and interesting pan effects.
For example, patch a mono loop through two channels of the Transient De-
signer and pan fully left and right in the mix. Process the left channel with
increased ATTACK and reduced SUSTAIN while you adjust the right chan-
nel the opposite way and you get very special stereo loop sounds. You have
to try this to appreciate what it sounds like, but expect to hear a lot of un-
usual stereo movement.
• Enjoy an amazingly simple integration of drum sounds into a mix. If the
acoustic level of a snare is expanded to approximately +4 dB by increasing
the attack value, the effective increase of peak levels in the overall mix is
merely about 0.5 dB to 1 dB.
Drums:
Ambience
If your drums happen to sound as if the room mics have been placed in a shoe
closet, the Transient Designer can immediately turn that sound into the ambi-
ence of an empty warehouse. Just send the stereo room mics through the Tran-
sient Designer and crank the ATTACK control to emphasize the first wave.
Now slowly increase SUSTAIN values to bring up an “all-buttons-in-1176-
sound” room tone—but without pumping cymbals. For a solid and driving
rhythm track just fine-tune the SUSTAIN control to make sure that the room mic
envelope ends more or less exactly on the desired upbeat or downbeat.
To Next Page
Loading...
Need help?
General
