UAD Powered Plug-Ins Manual - 288 - Chapter 33: Precision K-Stereo Ambience Recovery
Ambience Recovery
Refer to Figure 88 below for the controls in this section.
Recover Enable This switch enables/disables the ambience recovery process. See “Ambience
Recovery” on page 286 for an overview.
Recover Enable must be engaged for the Ambience Gain, Enhance
Deep/Wide, and Ambience Filters controls to have an effect.
Note: This switch does not have any effect on the M/S Gain, L/R Gain, or
Power controls.
Ambience Gain The Ambience Gain knob controls the level of recovered ambience. The de-
fault 0 dB position is defined as the nominal or “typical” setting (ambience re-
covery is occurring when set to 0 dB).
Increase or decrease Ambience Gain to change the amount of recovered am-
bience. The range is -20 dB to +9 dB, available in 0.5 dB steps. Click the “0”
label to quickly return to 0 dB. To disable ambience recovery, use the Recover
Enable switch.
Note: Values below 0 dB do not remove ambience.
Enhance The ambience recovery process can be manipulated further with the Deep
and Wide switches.
Note: The Enhance functions can only be enabled when the Recover switch
is engaged.
Deep
Provides deeper ambience recovery when the switch engaged.
Wide
Spreads and enhances the stereo image when the switch is engaged.
Figure 88. The Ambience Recovery controls
To Next Page
Loading...
Need help?
General
