UAD Powered Plug-Ins Manual - 114 - Chapter 10: EMT 250 Electronic Reverberator
EMT 250 Screenshot
Functional Overview
Program Modes The EMT 250 offers six effect types: Reverb, Delay, Phase, Chorus, Echo, and
Space. These effects are called “program modes” in the EMT 250. Only one
mode can be active at a time.
Each program mode has up to five parameters that can be modified by the
four main control “levers” plus the front/rear switch. The function of these con-
trols varies per program mode (see below). Additionally, there are several
global controls that have the same function in all modes.
Variable Control
Functions
The function of control levers 1, 2, 3, and the Front/Rear switch depends
upon which program mode is active. This is a primary consideration to re-
member when operating the EMT 250. Table 10 on page 117 details the
varying functions of the control levers and the front/rear switch in each mode.
Important: The function of the “levers” and the front/rear switch changes
depending on the program mode.
Figure 40. The EMT 250 plug-in window
To Next Page
Loading...
Need help?
General
