Universal Audio Ampex ATR-102 - Parameter Dependencies

UAD Powered Plug-Ins Manual - 44 - Chapter 2: Ampex ATR-102
Parameter Dependencies
Available
Settings
Some ATR-102 parameter value ranges depend on the value of other param-
eters. These dependencies are listed in Table 6 below.
Ampex ATR-102
Latency
The Ampex ATR-102 uses an internal upsampling technique. This upsampling
results in a larger latency than most other UAD plug-ins. See “UAD Delay
Compensation” in the UAD System Manual for more information.
Table 6. Ampex ATR-102 parameter dependencies
Tape Speed Head Width Tape 1 Tape 2 Tape 3 Tape 4 Emphasis EQ
30 IPS 1” 250 456 468 GP9 AES
30 IPS 1/2” 250 456 900 GP9 AES
30 IPS 1/4” 250 456 900 GP9 AES
15 IPS 1” 250 456 468 GP9 NAB
15 IPS 1” 250 456 468 GP9 CCIR
15 IPS 1/2” 250 456 900 GP9 NAB
15 IPS 1/2” 250 456 900 GP9 CCIR
15 IPS 1/4” 250 456 900 GP9 NAB
15 IPS 1/4” 250 456 900 GP9 CCIR
7.5 IPS 1/4” 250 456 35-90 111 NAB
7.5 IPS 1/4” 250 456 35-90 111 CCIR
3.75 IPS 1/4” 250 456 35-90 111 NAB
3.75 IPS 1/4” 250 456 35-90 111 CCIR