Side 3 af 26 UR-FK 2011
Background
Universal Robots Industrial Robots are a quality product, designed and produced in
Denmark by highly qualified technicians and engineers.
The robot has a service interval of 7,000 to 10,000 hours of operation. At this point it
should be lubricated with new grease.
Different circumstances may mean that it is necessary to service the robot sooner
than the interval indicated above.
For example, the robot may have been overloaded on an overrun or it may have been
dropped on the floor when relocating or have run with a load not recommended by
Universal Robots.
Purpose
The purpose of this Service Manual is to help the reader perform general servicing and
replace defective components in the robot.
Universal Robots recommends that you do not attempt repair, adjustment or other
intervention in the mechanical or electrical systems of the robot. Any unauthorised
intervention will invalidate the guarantee.
In the event of a defect, Universal Robots recommends ordering a new component
from the Universal Robots dealer who supplied the robot. Alternatively, you can order
from your nearest dealer, whose details you can obtain by contacting Universal Robots
at the following address:
Universal Robots ApS
Svendborgvej 102
DK-5260 Odense
Denmark
Tel.: +45 89 93 89 89
Fax +45 38 79 89 89
sales@universal-robots.com
www.universal-robots.com
To Next Page
Loading...
Need help?
General
