How to fix Processor overloaded error in Universal Robots UR5 Robotics?
If your Universal Robots robotics system reports 'Processor overloaded', review your program or remove some external controls and communications.
How to troubleshoot Lost communication with Safety Control Board A uP on Universal Robots UR5?
If your Universal Robots robotics system loses communication with Safety Control Board A uP, check the TCP/IP connection between the Motherboard and Control Board. Perform a complete rebooting sequence. If the issue persists, replace the Safety Control Board.
What causes 'Lost package from joint 1' in Universal Robots UR5?
If your Universal Robots robotics system is experiencing the error 'Lost package from joint 1', it means a serial communication problem with one or more joints. Verify that the communication cables are properly connected and perform a complete rebooting sequence.
What causes 'Packet counter disagreement in packet from Secondary Euromap67' in Universal Robots robotics?
General| Payload | 5 kg |
|---|---|
| Reach | 850 mm |
| Degrees of Freedom | 6 |
| Weight | 20.6 kg |
| Repeatability | ±0.1 mm |
| Power Supply | 100-240 VAC, 50-60 Hz |
| Operating Voltage | 24 VDC |
| Protection Rating | IP54 |
| Programming Method | Polyscope graphical user interface |
| Operating Temperature | 0°C to 50°C |
| Communication Interface | Ethernet |
To Next Page
