OPERATORS CARE OF SLICER
CLEANING
Warning: 1.
Never touch the knife edge. Always keep your hands, fingers and arms
clear of knife.
Warning: 2. Turn off slicer and DISCONNECT ELECTRICAL CORD (Figure 1 [10])
before cleaning. Leave protective guard (Fig. 2 [7]) in place.
3. Turn slice adjustment knob (Figure 1 [13]) to the fully closed position
(beyond "0") so that the knife edge is not exposed.
Caution:
4. Remove carriage assembly (Figure 1 [6]) which may be washed in a
sink. Use care in washing the sharply pointed prongs on the last slice
feed grip, (Figure 1 [8]). Wash this area thoroughly. A small bristle
brush is recommended. Use only warm water and mild soap. Rinse
carriage assembly with warm water and dry thoroughly using a clean
soft cloth.
Never use detergents or wash the slicer or any of its parts in a
dishwashing machine or the clear protective finish will be damaged.
Warning: 5.
Wash body of slicer using warm water and mild soap using a clean soft
cloth. Under no circumstances should the slicer be hose rinsed. It is
recommended that the cloth be folded over a thin wooden stick when
cleaning between the fence plate and the knife.
6. Remove knife guard (Figure 1 [5]) by loosening knife guard knob
(Figure 2 [46]) and pushing the long stud upward to lift knife guard
above surface of knife. Then carefully lift and remove guard.
Warning: 7. CAREFULLY wash the front and rear of the knife with a cloth using
warm water and mild soap. It is recommended that the cloth be folded
over a th
in wooden stick as a further caution to avoid accidental contact
with the knife edge. CAREFULLY wash between the knife edge and
protective guard (Figure 1 [12]) using a soft cloth inserted between
knife edge and guard on both front and rear of knife using extreme
caution to never touch the knife edge. Rinse with warm water applied
with a cloth. Dry thoroughly with a clean soft cloth.
Caution: 8. Following cleaning, a commercial non-toxic sanitizer may be wiped on
the clean surfaces with a soft clean cloth
or sprayed as recommended
on the container labeling. It is important that the sanitizer be compatible
with anodized aluminum or the clear protective finish on the slicer will
be damaged. Surface should be wetted completely, but not to the point
of running or puddling.
Warning: 9. Replace the knife guard. Never leave the slicer without its knife guard
installed!
Page 6
To Next Page
Loading...
