6.7 First startup of digital thermostats
At first startup, before registering, the thermostat
requires some basic settings.
See section 12 Operate Uponor Smatrix Wave/Wave
PLUS digital thermostats for more information.
Software version
Current software version is displayed during power up.
T-166
T-167
T-168
Set time (T-168 only)
When starting the thermostat for the first time, after a
factory reset, or after it has been left without batteries
too long, the software requires the time and date to
be set. This setting is required to utilise scheduling
programs for this thermostat.
Use buttons - or + to change the value, press the OK
button to set the value and move to the next editable
value.
NOTE!
If no button is pressed for about 8 seconds,
the current values will be saved and the
software exits to control mode.
1. Set hours.
2. Set minutes.
3. Set 12 h or 24 h display of time.
4. Set day of the week (1 = Monday, 7 = Sunday).
5. Set day of the month.
6. Set month.
7. Set year.
8. Press OK to return to run mode.
Date and time can also be set in the settings menu.
UK
CZ
DE
DK
EE
ES
FI
FR
HR
HU
IT
LT
LV
NL
NO
PL
PT
RO
RU
SE
SK
30
UPONOR SMATRIX MOVE/MOVE PLUS · INSTALLATION AND OPERATION MANUAL
To Next Page
Loading...
Need help?
General
