Uponor SmatrixMove User Manual

10 Time and date (T-168 only)
In this menu time and date is set. This setting is required
to utilise scheduling programs for this thermostat.
Use buttons - or + to change the value. Press the OK
button to set the value and move to the next editable
value.
To change this setting:
1. Press OK and the parameter starts flashing.
2. Set hours.
3. Set minutes.
4. Set 12 h or 24 h display of time.
5. Set day of the week (1 = Monday, 7 = Sunday).
6. Set day of the month.
7. Set month.
8. Set year.
9. Press OK to confirm change and return to the
settings menu.
10.10 Replace batteries
Replace the batteries of the thermostat when the low
battery icon
is shown in the display.
The illustration below shows how to change batteries.
2
1
3
1. Angle the thermostat from the bracket.
2. Remove it from the wall.
3. Replace batteries.
10.11 Factory reset
Factory reset sets all parameter values to default
settings.
NOTE!
Do not factory reset the thermostat if not
absolutely needed.
NOTE!
A factory reset removes the registration data
from the thermostat.
1. Press and hold the -, + and OK buttons for about
5 seconds until the screen goes blank.
2. The thermostat is now reset to factory default.
UK
CZ
DE
DK
EE
ES
FI
FR
HR
HU
IT
LT
LV
NL
NO
PL
PT
RO
RU
SE
SK
66
UPONOR SMATRIX MOVE/MOVE PLUS · INSTALLATION AND OPERATION MANUAL

Uponor SmatrixMove Specifications

General

Brand	Uponor
Model	SmatrixMove
Category	Temperature Controller
Language	English