Uponor SmatrixMove User Manual

6. Press the OK button to confirm, the days of the
week starts flashing.
1 2
34
5
6
7
7. Use buttons - or + to set the day of the week
(1 = Monday, 7 = Sunday).
8. Press the OK button to confirm, the days of the
week stop flashing.
9. Use buttons < or > to get back to Automatic
mode, or wait about 7 seconds for the controller to
revert automatically.
To select a scheduling program:
1. Press the > button repeatedly until the scheduling
program symbol
is marked in the display. One of
the available scheduling programs are available.
2. Use buttons -, + or OK to enter selection mode. The
selected program number starts flashing.
3. Use buttons - or + to select a scheduling program.
Use buttons < or > to preview the days of a
scheduling program.
Available programs: P1 – P9 (preset), U1 – U4 (user
defined).
4. Press the OK button to confirm selection of
scheduled program. If a user defined program (U1 –
U4) is selected, go to step 4.1.
4.1 If the selected user defined program is not in
need of change, press the OK button 7 times
until the digital clock disappears.
Otherwise, see section 8.5 Run mode >
Scheduling programs > User defined programs
for more information on how to create an own
program.
5. Use buttons < or > to get back to Automatic
mode, or wait about 7 seconds for the controller to
revert automatically.
See section 8.5 Run mode > Scheduling programs for
more information
Automatic mode
In this mode, the system switches automatically
between Comfort and ECO mode using the preset
or user defined scheduling programs available in the
Scheduled programs menu.
When entering the automatic mode menu, the
calculated supply and the current outdoor temperature
is shown for about 7 seconds.
0h 2101214161820
C
P
C
AUTO
22 24468
After these 7 seconds the current supply temperature
will be displayed instead of the calculated. The OK
button can be used to toggle between these two values
at any time, when in Automatic mode.
0h 2101214161820
C
P
C
AUTO
22 24468
Current time of the day will flash continuously at the
bottom of the screen showing which mode is currently
active (Comfort or ECO). This requires the time and day
to be set and a scheduled program to be selected.
To set time and day:
1. Press the > button repeatedly until the clock symbol
is marked in the display. A digital clock and the
number 1 through 7 is shown on the right hand side
of the display.
2. Press the OK button, the minutes starts flashing.
1 2
34
5
6
7
3. Use buttons - or + to set the minutes.
4. Press the OK button to confirm, the hours starts
flashing.
1 2
34
5
6
7
5. Use buttons - or + to set the hours.
UK
CZ
DE
DK
EE
ES
FI
FR
HR
HU
IT
LT
LV
NL
NO
PL
PT
RO
RU
SE
SK
42
UPONOR SMATRIX MOVE/MOVE PLUS · INSTALLATION AND OPERATION MANUAL

Uponor SmatrixMove Specifications

General

Brand	Uponor
Model	SmatrixMove
Category	Temperature Controller
Language	English