UPPAbaby MESA V2 User Manual

24
BASE INSTALLATION WITH LOWER ANCHORS
1
LEVELING THE BASE
1 Place the base on the vehicle seat with the adjustment
foot toward the vehicle seat back.
2 Press the level adjust button on the top of the base
to extend the foot and change the recline angle. Check
the angle indicators on either side of the base. The base
is level when only the GREEN marker is visible between
the two arrows. No RED should be visible.
LEVEL WHEN
NO RED
VISIBLE
LEVEL WHEN
NO RED
VISIBLE
NOTE: Vehicle must be parked on a level surface to
properly level the base.
2
If proper angle cannot be achieved
with adjustable foot, a rolled towel
may be used. Foot must be in fully
extended position.

UPPAbaby MESA V2 Specifications

General

Product Type	Infant Car Seat
Weight Capacity	4-35 lbs
Height Capacity	Up to 32 inches
Carrier Weight	9.9 lbs
Base	Included
Side Impact Protection	Yes
Adjustable Headrest	Yes
Height	24 inches
Width	17 inches
Safety Standards	FMVSS 213
Harness	5-point harness
Fabric	Merino wool
Base Installation	SmartSecure System
Stroller Compatibility	UPPAbaby VISTA and CRUZ strollers
Materials	Merino wool