UPPAbaby MESA V2 User Manual

51
1 Loosen the harness by pressing on the harness adjuster release button and pulling out the shoulder straps.
2 Open the retainer clip, unbuckle the harness, and tuck the latch plates into the side pockets to hold harness open.
3 Place infant in child restraint making sure their body is making full contact with the seating surface. Place harness over
child and insert buckle tongues into the buckle until a “click” is heard. Pull up on the buckle tongues to make sure they
are locked.
WARNING! DO NOT place rolled towel or small blanket between crotch
of infant and buckle or around head or SIP carriage. NEVER use non-
regulated products with this child restraint, unless approved by UPPAbaby.
GENERAL USE – Securing Your Child
1 2 3

UPPAbaby MESA V2 Specifications

General

Product Type	Infant Car Seat
Weight Capacity	4-35 lbs
Height Capacity	Up to 32 inches
Carrier Weight	9.9 lbs
Base	Included
Side Impact Protection	Yes
Adjustable Headrest	Yes
Height	24 inches
Width	17 inches
Safety Standards	FMVSS 213
Harness	5-point harness
Fabric	Merino wool
Base Installation	SmartSecure System
Stroller Compatibility	UPPAbaby VISTA and CRUZ strollers
Materials	Merino wool