28
BASE INSTALLATION WITH LOWER ANCHORS – Safety Check
Ensure tightness indicator is GREEN after each use. If it is not, apply pressure
by pushing base into seat bight (crease of seat) to tighten.
Recline angle is correct. Base is level when only GREEN is visible between
the two arrows on the level indicator. No RED should be visible.
Base doesn’t move more than 1" side-to-side and front-to-back at the belt path.
Lower anchor connector webbing is secure and untwisted.
LEVEL WHEN
NO RED
VISIBLE
LEVEL WHEN
NO RED
VISIBLE
To Next Page
Loading...
