UPPAbaby MESA V2 - Base Installation with Lower Anchors

25
LE
VE
L WHEN
N
O
RE
D
VISIBL
E
BASE INSTALLATION WITH LOWER ANCHORS
1 Locate the lower anchor connectors on either side of the base and remove
by pushing the corresponding orange button on the top of the base
1
while
pulling the connector out of the lower anchor storage pocket .
2 Attach the lower anchor connectors to the vehicle lower anchors located
in the vehicle seat bight (crease of seat).
NOTE: Check lower anchor connectors are in the upright position.
3 Apply pressure firmly into the base allowing all the excess lower anchor
connector webbing to retract and tighten.
LEVEL WHEN
NO RED
VI
SIBLE
1 32
REVIEW SAFETY CHECK ON PAGE 28.
ALL STEPS MUST BE ACHIEVED.
Push into the seat bight (crease
of seat). Installation is complete
when tightness indicator turns
from RED to GREEN and stays
GREEN when downward push is
discontinued.
1