65
CARE + MAINTENANCE – Seat Padding Installation
1 With the SIP in the lowest position, lay seat pad over
carrier, open Velcro® flap and fit opening around SIP/
headrest.
2 Tuck lowest side tab behind seat foam and under post.
Repeat on other side.
3 Place second side tab into designated plastic slot and
third side tab behind seat foam. Repeat on other side.
4 Tuck top 2 tabs into designated slots and pull headrest
adjuster tab through buttonhole
5 Lift lower part of SIP and pull harness straps to each side
of opening. Secure padding panel with Velcro®.
32
1
4 5
To Next Page
Loading...
