UPPAbaby MESA V2 User Manual

47
1"
INSTALLATION WITH LOCKING CLIP
1 While pushing into the child restraint, pull the seat
belt tight to eliminate any slack then pinch both pieces
of seat belt webbing directly behind the latch plate.
Unbuckle the belt without letting the webbing slip.
2 Thread the locking clip onto both lap and shoulder
belts 1" from the latch plate.
3 Re-buckle the vehicle belt.
CARRIER INSTALLATION WITH VEHICLE SEAT BELT
The locking clip can be found on the underside of the base (page 15). The locking clip can be used for
CARRIER installation with Lap/Shoulder belt combination when the seat belt does not lock.
1
3
2

UPPAbaby MESA V2 Specifications

General

Product Type	Infant Car Seat
Weight Capacity	4-35 lbs
Height Capacity	Up to 32 inches
Carrier Weight	9.9 lbs
Base	Included
Side Impact Protection	Yes
Adjustable Headrest	Yes
Height	24 inches
Width	17 inches
Safety Standards	FMVSS 213
Harness	5-point harness
Fabric	Merino wool
Base Installation	SmartSecure System
Stroller Compatibility	UPPAbaby VISTA and CRUZ strollers
Materials	Merino wool