35
LEVEL WHEN
NO RED
VISIBL
E
BASE INSTALLATION WITH VEHICLE SEAT BELT
Lap Belt Only Routing Method
3 With one hand push down base and hold firm as you pull
lap belt to tighten and remove any slack.
NOTE: Tightness indicator should be GREEN.
4 Close the top section of the lock-o over the belt then
close the bottom section of the lock-o over the belt.
Make sure you push the bottom of the lock-o all the
way down until you hear an audible click.
NOTE: Before closing the lock-o door, make sure the
vehicle seat belt has not slipped down into the belt path
and is as close as possible to the topside of the lock-o
where the door hinges.
LEVEL WHEN
NO RED
VISIBLE
REVIEW SAFETY CHECK ON PAGE 38.
ALL STEPS MUST BE ACHIEVED.
4
3
To Next Page
Loading...
