39 “Translation of the original instruction”
2.Apply a thin layer of new oil to the gasket of the
new hydraulic filter.
3.Install the new filter and tighten it by hand.
4.Use the permanent ink marker to write the date and
number of hours displayed on the timer on the
hydraulic filter.
5.Remove any oil spills that are spilled during the
replacement process.
6.Turn the key switch to the ground controller and
pull the red "emergency stop" button on the ground
controller and platform controller to the ON position.
Start the engine.
7.Raise the platform by about 1 meter.
8.Check the filter and related parts to ensure that
there is no leakage.
D-3
4.4.3 Replace the Wheel Oil
Note: The manufacturer-driven hub specification
requires this one-time procedure to be executed
150 hours after the first use.
Replacement Drive the hub oil is critical to
maintaining the machine's good performance and
service life. If the wheel oil is not replaced after
150 hours of initial use, it may cause the machine
to degrade and damage the parts if used
continuously.
1.Select the drive hub to replace the oil. Drive the
machine to one of the two stoppers at the lowest
point.
2.Remove the two stoppers and drain the oil into
the appropriate container.
3.Drive the machine to one of the two stoppers at
the highest point.
4.Refuel the wheel until the oil level is flat with
the bottom of the lowest plug.
5.Install the plug in the drive hub.
6.Repeat this procedure for other drive hubs.
To Next Page
Loading...
Need help?
General
