Upright X Series - Check Table B Program; Check the Battery; Check the Electrical Wiring; Check Tire, Wheel and Groove Nut Torque

21 “Translation of the original instruction”
Check Table B Y N R
B-1 Check the battery connections & fluid level
B-2 Check the electrical wiring
B-3 Check tyre, wheel and groove nut torque
B-4 Test emergency stop function
B-5 Test the key switch function
B-6 Test drive brakes
B-7 Test drive speed - stowed position
B-8 Test drive speed - raised position
B-9 Check the electrical contactor
B-10 Perform hydraulic oil analysis
B-11 Check the oil level in the drive hub
B-12 Replace the hydraulic tank return filter
B-13 Be sure the brake mechanism is correct
Check table C Y N R
C-1 Test platform overload pressure sensor and
platform height sensor (if equipped)
Check table D Y N R
D-1 Check the chassis and the platform slide blocks
D-2 Replace the hydraulic filter
D-3 Replace the wheel oil
D-4 Test hydraulic pump functions correctly
Check table E Y N R
E-1 Test or replace hydraulic oil
E-2 Apply grease to steering shaft and wheel bearings