45 “Translation of the original instruction”
1-1
5.1.1 Platform Removal
Controller Circuit Board Method
4.Push the red "emergency stop" button of the
ground and platform controller into the OFF
position.
5.
Disconnect the platform controller from the
control cable on the platform.
6.Remove the fasteners that secure the platform
control box to the platform controller bracket.
7.Remove the fasteners that secure the bottom
cover to the platform control box. Open the control
box.
8.Unlock the strap of the fixed harness.
9.Disconnect the red and black lines from the alarm.
10.Carefully remove the alarm from the platform
control box.
11.Carefully disconnect all harness connectors from
the platform controller board.
Risk of electric shock / burn. Exposure to live circuits
can result in death or serious injury. Remove all
rings, watches and other accessories.
Risk of damage to parts. Electrostatic discharge
(SED) can damage printed circuit board
components. When operating on printed circuit
boards, keep them in good contact with the metal
parts that are always grounded on the machine, or
use ground tapes.
1.Carefully remove the platform controller board
fasteners.
2.Carefully remove the platform controller board
from the platform control box.
3.Remove the transparent cap from the platform
controller board and save it.
Circuit board fasteners torque specifications
Tighten by hand until the screws are in place ﹤0.6Nm
CAUTION: Before installing the circuit board, place
the transparent cover removed in step 11 on the
board button.
CAUTION: After installing the circuit board, check
that the button is working properly. Excessive torque
on circuit board fasteners can cause excessive
torque. The circuit board fasteners do not make the
buttons fit properly.
To Next Page
Loading...
Need help?
General
