Upright X Series Service And Maintenance Manual

28 “Translation of the original instruction”
B-2
4.2.2 Check the Electrical Wiring
Instant UpRight specifications require this procedure to
be executed every 250 hours or quarterly, whichever
comes first.
Maintaining the electrical wiring is critical to safe
operation and good machine performance. Failure to
detect and replace burned, worn, corroded, or crushed
wiring may result in unsafe operating conditions and
damage to the parts.
Risk of electric shock / burn. Exposure to live circuits
can result in death or serious injury. Remove all rings,
watches and other accessories.
1.Check the ground bus below the chassis for damage
or loss.
2.
Check the following areas for wiring, burned,
corroded, and loose.
3. Rear axle:
Drive motor
Limit switch
 Hydraulic box:
Ground control inside
End connection
电 Motor Controller
Battery charger
 Battery box:
Battery
Fuse box
 Machine:
Center of drive chassis
Connecting rod assembly
Platform
Platform control
Harness connection
3.Check that all of the harness connectors are coated
with an adequate insulating grease layer:
 Ground controller
 Platform controller
 Functional manifold
 Motor controller
 Limit switch
 Level sensor
 Steering sensor

Upright X Series Specifications

General

Brand	Upright
Model	X Series
Category	Lifting Systems
Language	English