US Cutter MH-721 - Product Specifications

- 34 -
Specifications
Maximum Paper Feed Width
MH365(12 inch model) - 14.3 inches (365mm)
MH721(25 inch model) - 28.3 inches (720mm)
MH871(33 inch model) - 34.2 inches (870mm)
MH1351(50 inch model) - 53.1 inches (1350mm)
Maximum Cutting Width
MH365(12 inch model) - 10.8 inches (275mm)
MH721(24 inch model) - 24.8 inches (630mm)
MH871(33 inch model) - 30.7 inches (780mm)
MH1351(50 inch model) - 49.6 inches (1260mm)
Cutting Speed
4-48 Inches per second (100-1200 mm per second) In 4 inch per
second (100mm per second) increments
Pressure Range
10-400g In 10g increments
Maximum Cutting Thickness
.039 inches (1mm)
Buffer Capacity
1-4m
CPU
8 bit CPU
Carriage Positions
1 blade slot and 1 pen (plotter) slot
Cutting Strip
Double sheet (soft sheet and plastic sheet)
Motor
Stepper Motor
Minimum Character Matrix
Approximately .2 inches (5mm) high
Blade Type
Roland Cemented Carbide blades
Plotting Pen
All 11.4mm diameter plotting pens
Display Panel
8 digits x 2 line LCD
Communications Interface
USB (Universal Serial Bus) and RS-232 Serial (9 pin)
Power Requirements
90 – 260 VAC
Repeatability
0.127 mm
Mechanical Resolution
0.0254mm/step
Commands Set
DMPL/HPGL; automatic identification
Environmental Temperature
0-35˚ C
Environmental Humidity
5%-65% (without condensation)
Customer Service/Technical
Support Line
425-481-3555; Available 7am - 5pm, Mon-Fri
Online Technical Support
support.uscutter.com
E-mail: support@USCutter.com
Customer Forums
forum.uscutter.com
Manufactured For and Sold
Directly By
19510 114
th
Avenue NE, Suite C-1
Woodinville, WA 98072
425-481-3555 phone
888-640-0720 fax
www.USCutter.com