106
Reference
Some tests require both setpoints to be set (providing a
window or zone for test evaluation) while others require
only one (test outcome depends on if the level is reached
or passed). See page 38.
Rise Test: A test type which can be either a pressure rise or
vacuum rise test. The results are expressed as a positive
value if the pressure change is in the expected direction or
negative if otherwise. E.g., a typical pressure decay test
will have a positive value consistent with a positive
pressure delta where the pressure is actually decreasing.
RS-232: A serial communications protocol used by most
computers and computer peripherals. Sprint iQ uses an
RS-232 protocol to send test result data to printers and
computers.
Run: When the lockout key is in the vertical position, Sprint
is in Run Mode. Sprint iQ is set to run when used in
production testing. The only other keyswitch condition is
Program Mode (lockout key in horizontal position).
Run Display: The only screen visible when the lockout key is
in run (vertical) position. This display is visible to the
operator during testing.
Run/Program Switch: See Lockout Keyswitch.
SCCM: Abbreviation for Standard Cubic Centimeters per
Minute. This is a flow measurement standardized to 68
degrees Fahrenheit and 14.7 psi (average sea level)
Security key: A USB device that unlocks capabilities which
may be available for the tester.
Sensor: Sprint iQ uses two kinds of sensors-a pressure sensor
and a flow sensor. As an option, remote sensors can be
connected to Sprint for automated processes.
To Next Page
Loading...
