32
Menus
3.0.2.2 Program Mode Menu
Turn the Lockout Keyswitch to the horizontal position to go to
the Program Mode Menu. The ability to use the menu item will
vary depending on the configuration of the particular tester.
Highlight the first item, Test Parameter Menu, and press Enter.
The Test Parameter Menu will open and the display will appear as
shown below. The navigation method is similar in all menus.
Test Parameter Menu ...................See page 33
Data Menu ...................................See page 41
Setup Menu..................................See page 44
Hardware Menu ...........................See page 46
Factory Configuration Menu .......(Factory use only)
Software Version..........................(Display only)
5. Factory Configuration Menu
6. Software Version #.#.##
Program Mode
1. Test Parameter Menu
2. Data Menu
3. Setup Menu
4. Hardware Menu
To Next Page
Loading...
