Quick Start
5
Chapter 2
Quick Start
2.1 Fast-Track Setup
Connect clean, dry supply air.
Connect peripheral devices, if any.
Connect the power supply and turn on Sprint iQ. Turn the
connector’s collar until it is finger-tight to ensure a good
connection.
Use the back panel switch to turn on the Sprint iQ.
Turn the Lockout Keyswitch to the program position (horizontal).
Set the units of measure to use for pressure, flow volume, and
flow time.
Enter test parameters for the first program to run.
Enter test parameters for additional programs if you are using
more than one program.
Set communication values for the connected peripherals, if used.
Turn the Lockout Keyswitch to run position (vertical). Sprint iQ
is now ready to use.
Do not allow the power supply’s ventilation slots to be blocked.
The power supply has an automatic fan that runs as necessary to
prevent overheating.
To Next Page
Loading...
