EasyManua.ls Logo

Uson 628 - User Manual

Uson 628
93 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
Document No. 690020 - Rev.3.0
Operator’s Manual

Table of Contents

Question and Answer IconNeed help?

Do you have a question about the Uson 628 and is the answer not in the manual?

Summary

Chapter 1: Safety

Introduction to Safety

Explains the purpose of the safety section and the tester's intended use.

Safety Precautions

Details electrical and pneumatic hazards and precautions for safe operation.

Safety Alert Symbols

Explains the meaning of warning, caution, and note symbols used in the manual.

Chapter 2: Introduction

Uson 628 Overview

Provides an overview of the Uson 628 differential pressure decay tester.

Specifications

Lists the technical specifications of the Uson 628 tester.

Front Panel Overview

Describes the controls and connections on the Uson 628 front panel.

Leak Test Cycle

Describes the sequence of steps involved in a leak test cycle.

Chapter 3: Installation;Wiring

Wiring and Connections

Details the electrical and pneumatic connections required for the tester.

Rear Panel Overview

Illustrates and describes the component layout on the tester's rear panel.

Power Supply

Explains the power supply requirements and connection for the Uson 628.

Pneumatic Connections

Details pneumatic connections, air supply requirements, and filters.

Chapter 4: Getting Started

Turning the Tester On;Off

Provides instructions on how to power the Uson 628 tester on and off.

Menu Navigation

Explains how to navigate through the tester's menus and use controls.

Setting a Password

Provides steps to enable password protection on the tester.

Menu Item Access Control

Lists access control for menu items when password option is enabled.

Chapter 5: Program Mode

Entering Program Mode

Provides steps to enter the Program Mode menu.

Program Menu (submenus)

Details standard parameters for performing a leak test.

Set Up Menu

Allows adjustment of global operational settings and tester configurations.

Gauge Sensor Configuration

Details the configuration settings for the gauge sensor.

Chapter 6: Run Mode

Run Mode Overview

Describes the options available in Run Mode.

Run Mode Operations

Lists operations available when the tester is ready, like Program Mode.

Chapter 7: How To

Perform a Test

Provides instructions on how to initiate and conduct a test cycle.

Set Test Program Details

Guides on setting specific test parameters like reject levels and times.

Optimize a Program

Guides on adjusting parameters for optimum performance.

Program Linking

Covers automating tests by linking programs based on results.

Chapter 8: Leak Calibration (Comp;Cal)

Performing a Leak Rate Calibration

Guides on performing calibration using standard leaks.

Comp Test Procedure

Explains the Compensation test procedure.

Cal Test Procedure

Explains the Calibration test procedure.

Chapter 9: Maintenance

Routine Maintenance Schedule

Outlines the daily and weekly maintenance schedule for testers.

Fuse Replacement

Details the procedure for replacing the tester's power fuse.

Software Update

Provides instructions for updating the tester's software.

Chapter 10: Spares;Accessories

Available Spares

Lists available spare parts with part numbers for ordering.

Available Accessories

Lists available accessories for the Uson 628 tester.

Chapter 11: Appendix A - Sample Reports

Sample Reports

Provides sample reports for configuration, sensors, programs, etc.

Uson 628 Specifications

General IconGeneral
BrandUson
Model628
CategoryTest Equipment
LanguageEnglish

Related product manuals