Safety 1-1
1
Chapter 1Safety
1.1 Introduction
This section explains the warnings and cautions that should be observed before
using, wiring, installing, or operating the Uson 628.
Safety information is covered at relevant points throughout the manual. Please
read this manual in its entirety before installing/wiring or operating the instrument.
Should any point remain unclear, contact your supplier for assistance before
proceeding.
This tester is intended to be used in an industrial environment by suitably trained
personnel.
1.1.1 Using this Manual
The instructions in this manual are intended to assist qualified personnel for
correct installation, wiring, operating, adjusting, servicing, maintaining, and
troubleshooting of this tester.
1.1.2 Safety Alert Symbols
WARNING: Informs users of potentially hazardous situation, such as
personal injury or death and/or severe equipment damage, if instructions are
not followed.
CAUTION: Informs user of potential hazards to equipment if instructions are not
followed and may invalidate the warranty.
NOTE: Helps user perform task.
To Next Page
Loading...
