Uson 628 - Date Time Menu; Set up Menu

5-8 Uson 628 Operator’s Manual
5.3.5 Date Time Menu
The date time parameters are:
5.3.6 Set Up Menu
This menu allows the user to set-up or to alter the tester’s global operational
settings.These parameters cannot be modified when the password option is
enabled. The Set up menu parameters are:
Data Time Menu Parameters
Parameter Description
Year Calendar year setting.
Month Calendar month setting.
Day
Calendar day setting.
Hours
Clock hour setting.
Minutes
Clock minutes setting.
Note: The Time and Date will only be maintained for a limited duration (typically 14 days)
when the tester is turned off.
Set up Menu Parameters
Parameter Description
Gauge Units
This parameter defines the pressure units for gauge sensor related
pressure parameters. Options include:
bar, PSI, kPa and the default
is
PSI .
Diff Units
This parameter defines the pressure units for differential pressure
related pressure parameters. Options include: bar, PSI, kPa and the
default is
PSI .
Start Method
This parameter defines the method of starting and aborting a test
cycle in Run Mode.The options are:
Front: Front Panel Buttons,
default setting.
Remote: Control selected by remote inputs.
Remote Enable: This start method is selected by the remote enable
input: An open input enables front panel start button, a closed input
enables remote start input. For additional input information,
see
"Rear Panel" on page 3-2 .
Program
Selection
This parameter defines how the test program is selected in Run
Mode.The options available are:
Run Mode: The front panel Up/
Down function keys, default setting.
Remote: Remote binary and
Remote BCD
are via the remote I/O interface. For encoding, see
Section
See "Program Selection" on page 3-10 Program Mode:
Pre-selected in Program Mode to prevent user(s) from selecting other
programs.