9-4 Uson 628 Operator’s Manual
9.6 Software Update
Contact Uson Support to receive new software updates. Once you receive your
software update, copy the files (install.sh and 628) to a USB memory device in
folder \uson\628 (note: uson must be in lower case letters).
To install the new software, perform the following:
1. Complete login when password option is enabled.
2. Insert the USB memory device into the USB port and wait for the activity light
on the device to stop flashing.
3. Select Program Mode, Hardware, and Software Version menu.
4. Select the Update option, USB Device, to install new software version.
5. Once the update completes, return to Run Mode.
6. Power cycle the tester to finish the software update.
NOTE: Only USB devices formatted with FAT32 are supported.
To Next Page
Loading...
