Programming
79
4.1.8 Pass/Reject Jumps
The Sprint iQ tester has additional control to link the test
programs together based on either a pass or reject condition. This
feature also adds the ability to pause the test sequence between
linked test programs.
On Pass vs. On Reject
The settings are separated into two groups On Pass and On
Reject. The lines associated with On Pass control actions that are
only executed if the part passes and the test is accepted. The lines
associated with On Reject control actions that are only executed if
the part fails and the test is rejected.
Jump Menu
1. Program Selection 001
2. On Pass Pause Time 0.0s
3. On Pass Automatic Advance Off
4. On Pass Next Program Off
5. On Reject Pause Time 0.0s
6. On Reject Automatic Advance Off
7. On Reject Next Program Off
To Next Page
Loading...
