Section 6 COPIER MANAGEMENT
6-25
2 Press either the Zoom (+) or Zoom (–) key to display “F25”.
Inch specifications Metric specifications
3 Press the [OK] key.
Inch specifications Metric specifications
4 Press either the Zoom (+) or Zoom (–) key and select “on”
when the reverse side is to be rotated and “oFF” when no
rotation is to be performed.
Inch specifications Metric specifications
5 Press the [OK] key.
The display will return to that of Step 2.
Inch specifications Metric specifications
Margin Shift
Set the Margin Width.
1 Display the Default Settings Mode. (Refer to P.6-11
"Default Settings Mode Operations Procedures".)
Inch specifications Metric specifications
2 Press either the Zoom (+) or Zoom (–) key to display “F26”.
Inch specifications Metric specifications
3 Press the [OK] key.
Inch specifications Metric specifications
4 Press either the Zoom (+) key or the Zoom (–) key and set
the Margin Width within the range from
0.13/0.25/0.38/0.50/0.63/0.75(")/1 - 18 (mm).
Inch specifications Metric specifications
To Next Page
Loading...