5-23
Operation on the Machine > Sending
Confirmation Screen of Destinations
When selecting [On] for Destination Check before Send (Check beforeSend on page 8-35), the confirmation screen of
destinations appears after pressing the [Start] key.
Follow the steps below to confirm the destinations.
1 Press the [ā²] or [ā¼] key to confirm all destination.
To show the detailed information of the destination, select the destination and press the [OK] key.
Select [Detail] and press the [OK] key.
To delete the destination, select the destination you want to delete and press the [OK] key. Select
[Delete], press the [OK] key, and press [Yes] in the confirmation screen. The destination is deleted.
2 Press [Next].
Recall
Recall is a function allowing you to send the last entered destination once again. When you want to send the image to
the same destination, press the [Address Recall/Pause] key, and you can call the destination you sent on the
destination list.
1 Press the [Address Recall/Pause] key.
The destination you sent is displayed on the destination list.
2 Press the [Start] key.
Sending starts.
Be sure to confirm all destination by displaying them on the message display. You cannot
press [Next] unless you have confirmed all destination.
When the last sending included FAX, computers and e-mail destinations, they are also
displayed. If necessary, add or delete the destination.
ā¢ When [On] is selected in "Check beforeSend", a destination confirmation screen is
displayed when you press the [Start] key. For details, refer to Confirmation Screen of
Destinations on page 5-23.
ā¢ Recall information is canceled in the following conditions.
- When you turn the power off
- When you send a next image (new recall information is registered)
- When you log out
To Next Page
Loading...
Need help?
General
